Wifi Mac Changer Android latest 3.8 APK Download and Install. Change or Spoof Your Wifi Mac Address -and access any filtered Wireless Networks. #Title:SMAC MAC Address Changer v2.0.5 Professional crack #Tags:smac,mac,address,changer,professional SMAC MAC Address Changer v2.0.5 Professional crack Rating Related Downloads Downloads Piacere.Michele.Imperatore.2008.iTALiAN.LiMiTeD.DVDRip.XviD-SmAc patch 6773 SMAC 1.2 (change mac address).zip keygen 9251 Smac 2.0- #Planned# keygen 7284 Smac 2.7 beta for Vista and Windows 7 patch 9280 SMAC.
- Ubiquiti Mac Address Changer V3 0 Free Download And Install
- Ubiquiti Mac Address Changer V3 0 Free Download Version 9 0
I’m writing this down so I can find it later.
The management IP address on my Unifi US-16-XG is wrong. I’m going to change it via a combination of the controller and the CLI. Let’s hope this works.
Ubiquiti Mac Address Changer V3 0 Free Download And Install
Hope? Why hope?
Unifi switches are designed to be managed via the webgui (i.e. their controller).
I’m sure this will also work on my US-48 switch too.
Get connected and get in
I’ve done this both via ssh and via the serial port.
You can ssh to your device, using the same credentials you use on your Unifi controller. You’ll see something like this:
If you connect via the serial port, you may have to play around with the baud rate. I suggest you keep increasing it until it works. From my MacBook, this works for me:
You’re in!
OK, I’m in. Now, what do I telnet to?
In the above, you can see two items of interest:
- 10.0.0.249:22 – the original ssh connection
- 127.0.0.1:2222 – my next connection
Here we go:
NOTE: you have to hit ENTER a second time for that Warning and prompt to appear.
Configuration mode
Let’s enable the configuration mode.
Ubiquiti Mac Address Changer V3 0 Free Download Version 9 0
Help!
What to do next?
Ahh! I’ll try network.
Network
I changed the IP address (10.125.0.220) and set the gateway (10.125.0.1) like this:
Then I altered the management VLAN:
show
Let’s see what we have now:
The US-48
The US-48 had lost contact with the controller. I connected via the serial console and entered this command:
Then I checked to see what it had:
Good. Checking the controller, the device was connected. There was a ‘STUN Communication Failed’ message. From my reading, that will do way when I reprovision the switch, which I am about to do in order to change the management IP address.
After provisioning completed (which about a minute), info showed:
Now I need to change the management VLAN so it can communicate properly.
Hope this helps.